example-standalone-inferencing-ti-launchxl

This repository runs an exported impulse on the Texas Instruments LAUNCHXL-CC1352P1 development board. See the documentation at Running your impulse locally (TI CC1352P LaunchPad).

Texas Instruments Simplelink SDK

• Uses the TI Simplelink SDK simplelink_cc13x2_26x2_sdk_5.20.00.52
• Set SIMPLELINK_CC13X2_26X2_SDK_INSTALL_DIR in gcc\makefile to the path to TI SimpleLink SDK.

Building the application

1. Build the application by calling make as follows:

   $ cd gcc
   $ make
   

2. Connect the board to your computer using USB.

3. Flash the board

   Windows

   $ dslite.bat -c tools\user_files\configs\cc1352p1f3.ccxml -l tools\user_files\settings\generated.ufsettings -e -f -v gcc\build\edge-impulse-standalone.out
   

   Linux, macOS

   $ dslite.sh -c tools/user_files/configs/cc1352p1f3.ccxml -l tools/user_files/settings/generated.ufsettings -e -f -v gcc/build/edge-impulse-standalone.out
   

   Note: the above expects UniFlash is installed and PATH is set up properly to find dslite.sh.

Or build with Docker

1. Build the Docker image:

   $ docker build -t ti-build .
   

2. Build the application by running the container as follows:

   Windows

   $ docker run --rm -it -v "%cd%":/app ti-build /bin/bash -c "cd gcc && make"
   

   Linux, macOS

   $ docker run --rm -it -v $PWD:/app:delegated ti-build /bin/bash -c "cd gcc && make"
   

3. Connect the board to your computer using USB.

4. Flash the board:

   $ dslite.sh -c tools/user_files/configs/cc1352p1f3.ccxml -l tools/user_files/settings/generated.ufsettings -e -f -v gcc/build/edge-impulse-standalone.out
   

Troubleshooting

Flashing

If during flashing you encounter flashing issue. Then..

Ensure:

1. your device is properly connected and/or your cable is not damaged.
2. you have the proper permissions to access the USB device.

If on Linux you may want to try copying tools/71-ti-permissions.rules to /etc/udev/rules.d/. Then re-attach the USB cable and try again.