Update printhead.md

docs/hardware/printhead.md

@@ -102,13 +102,15 @@ The following picture shows the whole metal plate where the feeder construction
 ## Breakout Board  
 
 There's a PCB located at the printhead where the electronic components (e.g. thermistor, cartridge heater, ABL sensor etc.) are connected to which I call (for the sake of simplicity) "breakout board".    
-The more 'formal' name for this is "Hot End Nozzle Adapter Board Breakout Module" - so I'll stick with "breakout board".. ;)
+The more 'formal' name for this is "Hot End Nozzle Adapter Board Breakout Module" - so I'll stick with "breakout board".. ;)  
 
-![Breakout board](../assets/images/head_K2Neo_distri-pcb_web.jpg)  
+The following picture shows the breakout board with the extruder motor how you see it when removing the plastic housing of the printhead.  
 
-The following picture shows this breakout board from a slightly different angles, so that you can see the labels at the wires and the plugs and connectors a bit better.  
+![Breakout board and motor](../assets/images/head_K2_distri-pcb_sideview_web.jpg)  
 
-![Breakout board sideview](../assets/images/head_K2Neo_distri-pcb_labels_web.jpg)  
+The following picture shows the breakout board only with additional labels for the specific connectors.  
+
+![Breakout board labeled](../assets/images/head_K2Neo_distri-pcb_web.jpg)  
 
 The connection between the mainboard and this breakout board is then accomplished by a ribbon cable. The following picture shows the connector at the head and a part of that ribbon cable.  
 **As all connectors, this connector is coded - means, it only fits in ONE specific direction! Make sure to mind those 'noses' and notches and to plug it in correctly!**