enhancement request - full cutout of tip and tail spacer to get the core and spacer to a set fixed length

[splitn2]

Make the cam output full cutout of tip and tail spacer including the 3 straight sides and the shaped end that fits the core, to get the overall core and spacer to a set fixed length. So then the tip and tail spacer is attached to the core first with a small staple or epoxy or tape and becomes say a total of 170cm long, and then fits into 4 corner pockets or tabs in the cassette, like photo album books have on the corners of each photo that they slip into. This would just speed up production a tad and also basically nullify the chances of a mis alignment either by a mis placement during layup or a shift while moving the cassette. On the to do list not urgent just another idea to streamline the process. cheers Rich