ina219 setup screen issue

[KarlEffinger]

Hi Roland,

when using the INA219 Setup I get the following screen mixmatch ("Winkel" in red letters on same location as "Strom" in white letters")

Additionally I need to use the "Abbrechen" option to end the calibration and return to main menu.

(In addition to this bug, I have a question: what's this calibration module doing? Is there any documentation to it (besides the source code), that I could read?

Thank you so much for this great adaption of the hani mandl! I finished my construction work for a printable housing and also made a (simple, one board only) pcb. Are you interested in any of these and maybe want to share it on your project page?

Regards Karl

[RolandRust]

Hello Karl, I tested it at the weekend. It is actually the case that there is an error in the code. I'll correct it when I get the chance (but it might take a while since I'm currently in the process of dividing the code so that it's no longer all in one file.) The calibration doesn't actually do much. This only finds the minimum angle for closing the tap so that the servo does not press too hard on the screw. If you don't actually need it, you can also adjust it manually in the servo setting. Unfortunately I don't have any instructions. Because it's too much effort for me. Of course I'd be happy to take one if someone writes one. I'd rather invest my time in the code than in documentation :-) As far as the display output is concerned, there will be a major change anyway. I'm currently having massive problems with the TFT lib in conjunction with an ILI9488 display drive in combination with the ESP-S3 chip. (I still have something in mind with a 4 inch display with touch) If you have made a circuit board and a housing, you are welcome to send me the data (roland(at)greenmail.ch). I will then upload these to Git. Thank you very much for your report. It's always good when errors are found :-). Greetings Roli