Z-Axis set to zero instead of cutting depth on V-Shaped Iso Tool

[Lasermax3000]

Hi,

at first thank you for this awsome piece of Software.
I want to report an issue, on the 8.994 BETA Version with the Z-Axis.
The Problem is i use a V-Shaped Tool with a 30 degree angle and 0.1mm V-Dia.
In the Tool Libary i configured a cutting depth of 0.1mm and the Software calculates a Tool Dia of 0.1536mm.
So far so good, but when i generate the G-Code with this V-Tool the Cutting depth in the G-Code is only set to zero (no cutting).
I hope i´ve configured it the right way, it took me quiet a long time to figure out, that the G-Code was the issue not my Z-leveling.