These are the Cetus2 printable parts files, originally from the Cetus3D website.
These parts files are likely designed to be printed in ASA or ABS to withstand the heat, though some of the parts don't need to be able to deal with high temperatures.
On my printer all of the parts are printed in black, except for the wifi antenna cover that was printed in white.
Here is a handy dandy in-your-browser STEP file viewer.
| File | Description | Notes |
|---|---|---|
| cable clamp | Rainbow cable clip that clips to the side of the Z axis backplate | Doesn't get warm, PLA safe |
| extruder cable clip1x | Holds extruder FFC cable, this is the base | Doesn't get warm, PLA safe |
| extruder cable clip2x | Holds extruder FFC cable, this is the clip part that holds the cable | PLA Safe |
| Extruder cover-dual fan | V2 extruder fan shroud, with 2x40mm fan holders. | Needs to be heat resistant |
| filament sensor bracket | Extruder PCB mounting bracket the extruder cover attaches to | Not the filament out sensor. Needs to be heat resistant |
| print cooling fan duct | Part cooling fan shroud, 30mm fan | Needs to be heat resistant |
| WIFI antenna mount | Clips to bottom of printer, wifi antenna attached with sticky tape | Doesn't get warm, PLA safe |
| X PCB shield | Bracket you slide the X-motor FFC cable through during unpacking | Gets warm from stepper motor? |
| X-bet connector | Attaches X-belt to extruder head bracket | Needs strength and rigidity |
| Y- belt connector strengthened | Attaches Y-belt to X-axis motor, revision 2 adds overhang and bolt hole | Not used on my printer! |
| Y-axis FFC bracket | Back side of Y axis, by rainbow cable. Uses same cable clip. | Doesn't get warm, PLA safe. |
| Y-belt connector | Attaches Y-belt to X-axis motor, first revision | Used on my printer. Needs strength and rigidity |
Several other parts of the printer are not 3D printed, but likely could be to improve things. If I take the plunge I'll be adding any files I create here as well.
- Alternate filament feeder for TPU that may fit on the Cetus2 extruder.
- Another alternate filament feeder, with a spring and sized for a standard 11mm gear. May not properly fit in a Cetus2 extruder, experiment needed!