P1P2 Pinout for EHSXB08P30E

[nicx]

Hey, I think I have "tomatoes on my eyes"... maybe someone can help where to find the correct P1P2 pins on my EHSXB08P30E?

[KalaNagHTD]

If it is the old Version of the ECH2O with just one central knob (instead of two) the P1P2 functionality does not exist.Am 18.07.2023 um 08:48 schrieb nicx ***@***.***>: Hey, I think I have "tomatoes on my eyes"... maybe someone can help where to find the correct P1P2 pins on my EHSXB08P30E? —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[nicx]

@KalaNagHTD it is the new one with 2 knobs :)

[KalaNagHTD]

Look for connector X15M on the mainboard (pins 11 and 12)Am 18.07.2023 um 09:28 schrieb nicx ***@***.***>: @KalaNagHTD it is the new one with 2 knobs :) —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you were mentioned.Message ID: ***@***.***>

[nicx]

@KalaNagHTD found it, its labeled "User Interface". So I assume P1 is pin 11 and P2 is pin 12?

[KalaNagHTD]

According to the manual 11-12 = P1-P2Am 18.07.2023 um 11:07 schrieb nicx ***@***.***>: @KalaNagHTD found it, its labeled "User Interface". So I assume P1 is pin 11 and P2 is pin 12? —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you were mentioned.Message ID: ***@***.***>

[Arnold-n]

Indeed, but P1 and P2 can be swapped; although there is a polarity, all controllers accept wiring either way.